Our Promise To You

My Environmental Promise: I use Forest Stewardship Council certified woods or woods salvaged from downed trees. All boards are glassed with epoxy resin which is cleaner for our environment and emits 50-75% less Volatile Organic Compounds than polyester resin. In my shop I have moderate ventilation and no need for a mask when glassing. Epoxy is lighter and stronger than polyester. My wood boards are nearly indestructible and should last a lifetime. Each board is quality crafted for strength, durability and concern for our environment.

My Satisfaction Promise: Ride your board for 30 days. If you don't like it, return it.

CONTACT: Dan Johnston BlindDogSurfboards@yahoo.com

All images are copyright protected and my not be used without permission from Blind Dog Surfboards.


Oct 18, 2011

7'5" Fish

Finished shaping this Walnut, Spruce, Cedar Fish. Going to be glassed with 4 oz on bottom and two 4 oz on top, with epoxy. Fins are Walnut. Probably come in around 11 pounds. Going to glass it shortly. If you're interested, give us an email.






Oct 15, 2011

Southport, NC Wooden Boat Show 2011

Fun day. Kind of warm but Fall is approaching and, well it'll start getting cold soon. Down here we measure the season but wetsuit specs:  It's a 3/2 day or 5/4/3 and hood - gloves- booties day. So this one was rash guard and trunks kind of day. Tom sold two wall hangers and Charlie came over to pick up my Old Dog, pic of him using it below.

Oct 5, 2011

A Board For Myself

Hybrid Nose Rider is done. Now just need some waves to test drive her. Click on images to enlarge them.










Well my last 'personal stick' is gone and riding a Surftec 10'6" glider just doesn't cut it. Charlie got my personal stick, so time to make one for myself. It's a nose rider, 4" rear rocker and 2.5-3" front rocker. Concave under nose that tapers to a shallow V towards tail. Rails are pinched up from bottom deck and tapered quickly down on top. Since there is no way to put a 1/4" sq chine around the ribs, it is replaced with two 1/4" upper rib braces near center spar. PITA to get it all lined up to avoid frame warping. Also, try to get 3/16" decking to bend into concave - not easy. Ended up using a chair seat plane I made years ago for set of Windsor Chairs.

Our regular wood boards use 3/4" rail (3 of them) that start at bottom deck and go up along the ribs. This one, because of how pinched the rails are, takes 4 rails to make the same bend. Some make large fat noses, I'm staying with our traditional round that is slightly smaller. I think it makes for easier wave catching in hard off-shore windy days. Bottom deck is book matched spruce and top is western cedar and spruce. I've been saving a really sweet set of spruce that has red fungus/mineral stains in it. Looks very interesting. Hope to glass next week.